PDS & PDMS

Preparation of 3D models with MicroStation for PDS

For the generation of 3D models on MicroStation the pipe supports are first prepared as 2D models. The 2D data are then transposed into 3D data by LICAD and transferred via an interface into the MicroStation 3D model.

The secondary steel required is supplemented in the 3D model. In PDS the 3D models so generated can be used for interference checks.

Support design of 3D models in PDMS

For the design of 3D pipe system supports in the PDMS program, the customer makes a PDMS model complete with pipe systems, steel and all structural components available. The data list is required for the design of pipe supports.

The support points, including the necessary secondary steel, are planned and laid out directly in the PDMS 3D model by experienced designers. LICAD provides the well-tried basis for this. The load chains generated in LICAD, transposed into 3D data, are integrated into the model with the aid of a PDMS interface. Any secondary steel required can be directly supplemented in PDMS.

Finally, an examination of possible obstructions (interference check) is carried out in the 3D model. The customer receives a complete, fully checked 3D model with all planned support positions and the relevant 2D drawings, including parts lists. The support drawings can also be generated in the 3D mode if required.